magnetic separation Each with a plurality of holes are offset

the crusher bowl-shaped bearing frame how to install Crusher and cone crusher are Heavy Yu hair heavily built professional crusher and crushing effects are very good, but in its structure
Aspects still some differences, such as in the bearing, Yu hair crusher on the use of the bowl-shaped bearing frame, magnetic separations then the bearing frame should be considered how to install it correctly
? Yu hair below summarizes the technical staff Heavy specific installation steps, hope for everyone to use helpful:
a. hex bolts through the crusher bowl-shaped tile rack holes, screwed into the hole on the rack.
b. bowl-type bearing frame placed Crusher rack and bowl-shaped tile rack holes and threaded holes on the rack alignment. To ensure that a proper installation, the two
Each with a plurality of holes are offset.
c. To prevent individual effort, Neodymium Motor Magnets to turn the bolt, so that every time the power is not too large. If the maximum amount of interference, pressed into the bowl with the bolt tile frame is very difficult, it can be
Crusher bowl-shaped tile rack frame with the mating surface is heated above that of the ambient temperature around 400C.
d. tighten all the bolts to ensure crusher bowl-shaped tile rack with the rack fitting surface completely fit.
e. will be installed after the felt ring seal trap in the crusher bowl-shaped tile rack, to align the anti-rotation pin slot.
f. put pressure on the contractors, check seals crusher degree of flexibility. After the sealing ring is pressed by the spring force should be flexible under the action back to the original
Position.
g. cleanup crusher bowl-shaped outer surface of the tile frame and the spring bore, the spring sleeve uniform Magnetic Grates inner and outer surfaces painted some grease, and sets the compression spring. However
The bowl-shaped tile will be placed on the shelves spring hole.
h. Thoroughly clean crusher ring groove foreign body, and fill the grease.